Monday, December 5, 8: The mce remote shown in the above picture working as plug n play, that is without Eventghost. Then you need to reboot. Note that once you have recorded the pronto codes for your SB, you can use any remote to control it, or even use a webserver to control it I hope my explanations will help you! I may be able to understand better after I look at that. You do not have the required permissions to view the files attached to this post. My suspicion is a bad driver for the Microsoft Remote Control Receiver, but I can find no alternative one.

Uploader: Tygokinos
Date Added: 10 October 2013
File Size: 56.27 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64781
Price: Free* [*Free Regsitration Required]

Sorry this didn’t help.

To use an internal receiver or extender board they need to be connected as a system inside the computer. Javascript is disabled in this browser. How do I know my IR blaster is working in Sage? Unplug the end of the USB cable on the remote sensor from the computer and plug it into a different USB port on the computer.

The time now is I just need single solution. Example of an IR receiver built into a media card reader. It previously wored stuck to the front of the STB. By continuing to browse this site, you agree to this use. Visit our Microsoft Answers Feedback Forum and let us know what you think.

Related Drivers  MS 7390 VER 1.0 DRIVER FOR WINDOWS 7

A receiver device can be external and attached to a long cord or it can be built into the computer case or media card reader. Any assist is appreciated.

If the pressed buttons continue to it, try altering the lighting conditions in the room or moving the location of the remote sensor. Now, everytime you click on that button on the remote, it should fire the associated action.

When an IR Blaster cable is connected to a set-box, the code to change the channel up or down is sent to set-top box when the remote control is pointed at the PC not the set-top box. I setup my dad’s awhile back and I can tell you there is a setting that will work. There are no errors, it just fails to change the channel. You can follow the question or vote as helpful, but you cannot reply to this thread.

Remove From My Forums. Then went on to click add event on the macro, one of the event appeared automatically below the macro.

EventGhost

I downloaded Girder, but I can’t figure how it ties in. Example of a TV blastsr system with extender – controller on extender. Point the remote control at the remote sensor within a degree range, and less than 26 feet 8 meters away. If possible please look at it and advice if any mistakes been made.

Related Drivers  Eurotherm 2416 manual ePub

Originally Posted by mschoen. Let hardware detection reinstall the devices.

ehome ir blaster – SageTV Community

It sounds like a chicken and egg situation. You’ll have bkaster test, so you’ll need to install. Restart the computer, and then try the remote again.

Please help me as I am trying desperately to make this work. Last edited by mschoen; at This site in other languages x. The ends of the blaster cables can be connected to IR receivers built into TV or satellite set-top boxes. If the light appears, then the problem is probably in the software that is using the remote sensor most likely the Media Center software. Originally Posted by StephaneM.